Lldp Management-Address - Allied Telesis x510-28GTX Command Reference Manual

LLDP C
OMMANDS
-
LLDP MANAGEMENT ADDRESS

lldp management-address

Overview This command sets the IPv4 address to be advertised to neighbors (in the
Management Address TLV) via the specified ports. This address will override the
default address for these ports.
The no variant of this command clears the user-configured management IP
address advertised to neighbors via the specified ports. The advertised address
reverts to the default.
lldp management-address <ipaddr>
Syntax
no lldp management-address
Default The local loopback interface primary IPv4 address if set, else the primary IPv4
interface address of the lowest numbered VLAN the port belongs to, else the MAC
address of the device's baseboard if no VLAN IP addresses are configured for the
port.
Mode Interface Configuration
Usage To see the management address that will be advertised, use the
interface
Examples To set the management address advertised by ports 1.0.1 and 1.06, to be
192.168.1.6, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To clear the user-configured management address advertised by ports 1.0.1 and
1.0.6, and revert to using the default address, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show lldp interface
Commands
show lldp local-info
C613-50170-01 Rev B
Parameter
<ipaddr>
command or show lldp local-info
configure terminal
interface port1.0.1,port1.0.6
configure terminal
interface port1.0.1,port1.0.6
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The IPv4 address to be advertised to neighbors, in dotted
decimal format. This must be one of the IP addresses already
configured on the device.
command.
lldp management-address 192.168.1.6
no lldp management-address
show lldp
2616