Show Atmf Area - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

SHOW ATMF AREA

show atmf area
Overview Use this command to display information about an AMF area. On AMF controllers,
this command displays all areas that the controller is aware of. On remote AMF
masters, this command displays the controller area and the remote local area. On
gateways, this command displays the controller area and remote master area.
show atmf area [detail] [<area-name>]
Syntax
Mode Privileged Exec
Example 1 To show information about all areas, use the command:
controller-1#
The following figure shows example output from running this command on a
controller.
Table 5: Example output from the show atmf area command on a Controller.
controller-1#show atmf area 

ATMF Area Information: 

* = Local area

Area
Name
----------------------------------------------------------------------------
* NZ
Wellington
Canterbury
SiteA-AREA
Auckland
Southland

Area count:
The following figure shows example output from running this command on a
remote master.
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
detail
Displays detailed information
<area-name>
Displays information about master and gateway nodes in the
specified area only.
show atmf area

Area Local
ID Gateway
1 Reachable
2 Reachable
3 Reachable
14 Unreachable
100 Reachable
120 Reachable
6
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Remote Remote
Gateway Master
N/A N/A
Reachable Auth OK
Reachable Auth Error
Unreachable Unreachable
Reachable Auth Start
Reachable Auth OK
Area node count:
Node
Count
3 
120 
- 
- 
- 
54
177
2335