59
Introduction
Overview
LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the
Allied Telesis Enterprise MIBs in AlliedWare
The Voice VLAN feature can be configured using commands in
chapter.
For more information about LLDP, see the
Configuration
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List
•
•
•
•
•
•
•
•
•
•
•
C613-50170-01 Rev B
LLDP Commands
Guide.
SNMP Feature Overview and Configuration
"clear lldp
statistics" on page 2610
"clear lldp
table" on page 2611
"debug
lldp" on page 2612
"lldp
faststart-count" on page 2614
"lldp
holdtime-multiplier" on page 2615
"lldp
management-address" on page 2616
"lldp
med-notifications" on page 2617
"lldp
med-tlv-select" on page 2618
"lldp
non-strict-med-tlv-order-check" on page 2621
"lldp
notification-interval" on page 2622
"lldp
notifications" on page 2623
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Plus).
VLAN Commands
LLDP Feature Overview and
Guide).
Support for
2608