Discovery - Allied Telesis x510-28GTX Command Reference Manual

Stackable gigabit edge switches x510 series
Table of Contents

Advertisement

A
T
M
F
LLIED
ELESIS
ANAGEMENT

DISCOVERY

discovery
Overview
AMF nodes gather information about guest nodes by using one of two internally
defined discovery methods: static or dynamic. This is one of several modal
commands that are configured from within its specific guest-class (mode).
Dynamic discovery (the default method) involves learning IP address and MAC
addresses of guest nodes from protocols outside of AMF such as LLDP or DHCP
snooping. Dynamic learning is only supported when using IPv4. For IPv6 the static
discovery method must be used.
Note that if the discovery method is dynamic, you should ensure that the
command
The static method involves entering the guest class name and IP address using the
switchport atmf-guestlink
to each of the guest nodes. The MAC addresses of each of the guests of that class
can then be learned from ARP or Neighbor discovery tables. If you are using the
static discovery method, you must ensure that you have configured the
appropriate class type for each of your statically discovered guest nodes.
The no variant of this command returns the discovery method to dynamic.
Syntax
discovery [static|dynamic]
no discovery
Default
Dynamic
Mode
ATMF Guest Configuration Mode
Usage
This command is one of several modal commands that are configured and applied
for a specific guest-class (mode) and whose settings are automatically applied to a
guest-node link by the
Example 1
To configure the discovery of the guest-class camera to operate statically, use the
following commands:
Node1#conf t
Node1(config)#atmf guest-class camera
Node1(config-guest)#discovery static
Node1(config-guest)#end
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK
OMMANDS
ip dhcp snooping delete-by-linkdown
Parameter
Description
static
Statically assigned
dynamic
Learned from DCHCPSN or LLDP
switchport atmf-guestlink
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
command to separately assign an individual switch port
is set.
command.
2323

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents