Atmf Virtual-Crosslink - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
ATMF VIRTUAL CROSSLINK

atmf virtual-crosslink

Overview Use this command to create a virtual crosslink. A virtual crosslink connects an AMF
master or controller on a physical device to a Virtual AMF Appliance (VAA) master
or controller.
All AMF master nodes must reside in the same AMF domain and are required to be
directly connected using AMF crosslinks. In order to be able to meet this
requirement for AMF masters running on VAAs, a virtual crosslink connects the
AMF master or controller on the physical device to the master or controller on the
VAA.
Use the no variant of this command to remove a virtual crosslink.
atmf virtual-crosslink id <local-id> ip <local-ip> remote-id
Syntax
<remote-id> remote-ip <remote-ip>
no atmf virtual-crosslink id <local-id>
Default No AMF virtual crosslinks are created by default.
Mode Global Configuration
Usage This command allows a virtual tunnel to be created between two remote sites over
a layer 3 link. The tunnel encapsulates AMF packets and allows them to be sent
transparently across a Wide Area Network (WAN) such as the Internet.
Configuration involves creating a local tunnel ID, a local IP address, a remote
tunnel ID and a remote IP address. Each side of the tunnel must be configured with
the same, but mirrored parameters.
NOTE
multiple tenants on a single VAA host are configured for secure mode, only a single
AMF master is supported per area.
Example To setup a virtual link from a local site, "siteA", to a remote site, "siteB", (assuming
there is already IP connectivity between the sites), run the following commands at
the local site:
siteA#
siteA(config)#
remote-id 10 remote-ip 192.168.200.1
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
<local-id>
ID of the local tunnel port, a value between 1 and 4094.
<local-ip>
IPv4 address of the local tunnel port in a.b.c.d format.
<remote-id>
ID of the remote tunnel port, a value between 1 and 4094.
<remote-ip>
IPv4 address of the remote tunnel port in a.b.c.d format.
: Virtual crosslinks are not supported on AMF container masters, therefore if
configure terminal
atmf virtual-crosslink id 5 ip 192.168.100.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
2308