Location Civic-Location-Id - Allied Telesis x510-28GTX Command Reference Manual

LLDP C
OMMANDS
- -
LOCATION CIVIC LOCATION ID

location civic-location-id

Overview Use this command to assign a civic address location to the ports. The civic address
location must already exist. This replaces any previous assignment of civic address
location for the ports. Up to one location of each type can be assigned to a port.
Use the no variant of this command to remove a location identifier from the ports.
Syntax location civic-location-id <civic-loc-id>
no location civic-location-id [<civic-loc-id>]
Default By default no civic address location is assigned to ports.
Mode Interface Configuration
Usage The civic address location associated with a port can be transmitted in Location
Identification TLVs via the port.
Before using this command, create the location using the following commands:
•
•
If a civic-address location is deleted using the no variant of the
civic-location identifier
Examples To assign the civic address location 1 to port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove a civic address location from port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related lldp med-tlv-select
Commands
location civic-location identifier
location civic-location configuration
show location
C613-50170-01 Rev B
Parameter
<civic-loc-id>
location civic-location identifier
location civic-location configuration
command, it is automatically removed from all ports.
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Civic address location ID, in the range 1 to 4095.
command
command
location civic-location-id 1
no location civic-location-id
location
2637