Snmp-Server Startup-Trap-Delay - Allied Telesis x510-28GTX Command Reference Manual

SNMP C
OMMANDS
- - -
SNMP SERVER STARTUP TRAP DELAY

snmp-server startup-trap-delay

Overview Use this command to set the time in seconds after following completion of the
device startup sequence before the device sends any SNMP traps (or SNMP
notifications).
Use the no variant of this command to restore the default startup delay of 30
seconds.
snmp-server startup-trap-delay <delay-time>
Syntax
no snmp-server startup-trap-delay
Default The SNMP server trap delay time is 30 seconds. The no variant restores the default.
Mode Global Configuration
Example To delay the device sending SNMP traps until 60 seconds after device startup, use
the following commands:
awplus#
awplus(config)#
To restore the sending of SNMP traps to the default of 30 seconds after device
startup, use the following commands:
awplus#
awplus(config)#
Validation show snmp-server
Commands
C613-50170-01 Rev B
Parameter
<delay-time>
configure terminal
snmp-server startup-trap-delay 60
configure terminal
no snmp-server startup-trap-delay
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify an SNMP trap delay time in seconds in the range of 30
to 600 seconds.
2602