Switchport Atmf-Agentlink - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
SWITCHPORT ATMF AGENTLINK

switchport atmf-agentlink

Overview Use this command to configure a link between this device and an x600 Series
switch, in order to integrate the x600 Series switch into your AMF network. The
x600 Series switch is called an "AMF agent", and the link between the x600 and this
device is called an "agent link".
The x600 Series switch must be running version 5.4.2-3.16 or later.
Use the no variant of this command to remove the agent link. If the x600 Series
switch is still connected to the switch port, it will no longer be part of the AMF
network.
switchport atmf-agentlink
Syntax
no switchport atmf-agentlink
Default By default, no agent links exist and x600 Series switches are not visible to AMF
networks.
Mode Interface mode for a switch port. Note that the link between the x600 and the AMF
network must be a single link, not an aggregated link.
Usage The x600 Series switch provides the following information to the AMF node that it
is connected to:
•
•
•
•
•
•
•
AMF guestnode also makes most of this information available from x600 Series
switches, but requires configuration with DHCP and/or LLDP. AMF agent is simpler;
as soon the x600 is connected to an appropriately configured port of an AMF node,
it is immediately integrated into the AMF network.
To see information about the x600 Series switch, use the show atmf links guest
detail command.
Example To configure port 1.0.1 as an agent link, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show atmf links guest
Commands
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
The MAC address
The IPv4 address
The IPv6 address
The name/type of the device (Allied Telesis x600)
The name of the current firmware
The version of the current firmware
The configuration name
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
switchport atmf-agentlink
2418