Lldp Med-Notifications - Allied Telesis x510-28GTX Command Reference Manual

LLDP C
OMMANDS
-
LLDP MED NOTIFICATIONS

lldp med-notifications

Overview Use this command to enable LLDP to send LLDP-MED Topology Change Detected
SNMP notifications relating to the specified ports. The switch sends an SNMP event
notification when a new LLDP-MED compliant IP Telephony device is connected to
or disconnected from a port on the switch.
Use the no variant of this command to disable the sending of LLDP-MED Topology
Change Detected notifications relating to the specified ports.
lldp med-notifications
Syntax
no lldp med-notifications
Default The sending of LLDP-MED notifications is disabled by default.
Mode Interface Configuration
Examples To enable the sending of LLDP-MED Topology Change Detected notifications
relating to ports 1.0.1 and 1.0.6, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the sending of LLDP-MED notifications relating to ports 1.0.1 and 1.0.6,
use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related lldp notification-interval
Commands
lldp notifications
snmp-server enable trap
show lldp interface
C613-50170-01 Rev B
configure terminal
interface port1.0.1,port1.0.6
lldp med-notifications
configure terminal
interface port1.0.1,port1.0.6
no lldp med-notifications
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
2617