Domain-Name (Dhcpv6) - Allied Telesis x510-28GTX Command Reference Manual

DHCP IP 6 (DHCP 6) C
FOR V V OMMANDS
- (DHCP 6)
DOMAIN NAME V

domain-name (DHCPv6)

Overview Use this command in DHCPv6 Configuration mode to add a domain name to the
DHCPv6 server address pool you are configuring.
Use the no variant of this command to remove a domain name from the address
pool.
Syntax domain-name <domain-name>
no domain-name
Mode DHCPv6 Configuration
Usage This command specifies the domain name that a client should use when resolving
host names using the Domain Name System, and sets the domain name details
using the pre- defined option 15. Note that if you add a user-defined option 15
using the
with this command.
To add the domain name Engineering to DHCPv6 server pool P2, use the
Examples
commands:
awplus#
awplus(config)#
awplus(dhcpv6-config)#
To remove the domain name Engineering from DHCPv6 server pool P2, use the
commands:
awplus#
awplus(config)#
awplus(dhcpv6-config)#
Related dns-server (DHCPv6)
Commands
option (DHCPv6)
show ipv6 dhcp pool
C613-50170-01 Rev B
Parameter
<domain-name>
option (DHCPv6)
configure terminal
ipv6 dhcp pool P2
configure terminal
ipv6 dhcp pool P2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify the domain name you wish to assign the DHCPv6
server address pool. Valid characters are printable characters.
If the name contains spaces then you must enclose it in
"quotation marks".
command, then you will override any settings created
domain-name Engineering
no domain-name Engineering
2506