Location Coord-Location-Id - Allied Telesis x510-28GTX Command Reference Manual

LLDP C
OMMANDS
- -
LOCATION COORD LOCATION ID

location coord-location-id

Overview Use this command to assign a coordinate location to the ports. The coordinate
location must already exist. This replaces any previous assignment of coordinate
location for the ports. Up to one location of each type can be assigned to a port.
Use the no variant of this command to remove a location from the ports.
Syntax location coord-location-id <coord-loc-id>
no location coord-location-id [<coord-loc-id>]
Default By default no coordinate location is assigned to ports.
Mode Interface Configuration
Usage The coordinate location associated with a port can be transmitted in Location
Identification TLVs via the port.
Before using this command, configure the location using the following
commands:
•
•
If a coordinate location is deleted using the no variant of the
coord-location identifier
Examples To assign coordinate location 1 to port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove a coordinate location from port1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related lldp med-tlv-select
Commands
location coord-location identifier
location coord-location configuration
show location
C613-50170-01 Rev B
Parameter
<coord-loc-id>
location coord-location identifier
location coord-location configuration
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Coordinate location ID, in the range 1 to 4095.
command
command
command, it is automatically removed from all ports.
location coord-location-id 1
no location coord-location-id
location
2641