Switchport Atmf-Guestlink - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
SWITCHPORT ATMF GUESTLINK

switchport atmf-guestlink

Overview Guest links are used to provide basic AMF functionality to non AMF capable
devices. Guest links can be configured for either a selected switch port or a range
of switch ports and use generic protocols to collect status and configuration
information that the guest devices make available.
Use the no variant of this command to remove the guest node functionality from
the selected port or ports.
switchport atmf-guestlink [class <GUEST-CLASS>] [ip <A.B.C.D> |
Syntax
ipv6 <X:X::X:X>]
no switchport atmf-guestlink
Default No guest links are configured.
Mode Interface
Example 1 To configure switch port 1.0.44 to be a guest link, that will connect to a guest node
having a guest-class of camera and an IPv4 address of 192.168.3.3, use the
following commands:
node1#
node1(config)#
node1(config-if)#
192.168.3.3
node1(config-if)#
Example 2 To configure switchport 1.0.41 to be a guest link, that will connect to a guest node
having a guest-class of phone and an IPv6 address of 2001:db8:21e:10d::5, use
the following commands:
node1#
node1(config)#
node1(config-if)#
2000:db8:21e:10d::5
node1(config-if)#
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
class
Set a Guest-class
<GUEST-CLASS> The name of the guest class.
ip
Specifies that the address following will have an IPv4 format
<A.B.C.D>
The Guest-node's IP address in IPv4 format.
ipv6
Specifies that the address following will have an IPv6 format
<X:X::X:X>
The Guest-node's IP address in IPv6 format.
configure terminal
int port1.0.44
configure terminal
int port1.0.41
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
switchport atmf-guestlink class camera ip
end
switchport atmf-guestlink class phone ipv6
end
2423