Discovery Method - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
SHOW ATMF LINKS GUEST DETAIL
Table 54-2: Parameters in the output from show atmf links guest detail (cont.)
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
Parameter
Model Type

Discovery Method

IP Address
Username
Node state
Backup Supported
MAC Address
Device Type
Description
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The model type of the guest node, as entered by the
modeltype command. Can be one of the following:
• alliedware
• aw+
• tq
• other
The discovery method as applied by the
command. This can be either dynamic or static.
The IP address of the guest node.
The user name configured on the guest node.
The state of the guest node; one of:
• Down: The initial state when a link to a guest node is
first configured. This is also the state if the physical link
goes down.
• Getting IP: The AMF device is in the process of retrieving
the IP address of the guest node.
• Getting Mac: The AMF device is in the process of
retrieving the MAC address of the guest node.
• Getting Info: The AMF device is in the process of
retrieving any other available information from the
guest (firmware version etc). The information available
depends on what device the guest node is.
• Full: The AMF device has retrieved all necessary
information and the guest node has joined the AMF
network. Once this state is reached, the Link State also
changes to "Full".
• Failure: The physical link is up but the AMF member has
failed to retrieve enough information to allow the guest
node to join the AMF network.
Whether the guest node supports AMF backup
functionality.
The MAC address of the guest node.
Model information for the guest node. This field shows the
model information that AMF retrieved from the guest
node. In contrast, the Model Type shows what a user
entered as the type of device they intended this guest
node to be.
By default, this is a concatenation of the guest node's
parent node and the port to which it is attached. You can
change it by configuring a description on the port.
discovery
2387