Dhcp For Ipv6 (Dhcpv6) Commands; Introduction - Allied Telesis x510-28GTX Command Reference Manual

56

Introduction

Overview This chapter provides an alphabetical reference for commands used to configure
DHCPv6. For more information, see the
Configuration
DHCPv6 is a network protocol used to configure IPv6 hosts with IPv6 addresses and
IPv6 prefixes for an IPv6 network. DHCPv6 is used instead of SLAAC (Stateless
Address Autoconfiguration) at sites where centralized management of IPv6 hosts
is needed. IPv6 routers require automatic configuration of IPv6 addresses and IPv6
prefixes.
DHCPv6 Prefix Delegation provides automatic configuration of IPv6 addresses and
IPv6 prefixes.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
NOTE
3849 for documentation purposes. These addresses should not be used for practical
networks (other than for testing purposes) nor should they appear on any public
network.
Command List •
•
•
•
•
•
•
•
•
C613-50170-01 Rev B
Guide.
: The IPv6 addresses shown use the address space 2001:0db8::/32, defined in RFC
"address prefix" on page 2495
"address range" on page 2497
"clear counter ipv6 dhcp-client" on page 2499
"clear counter ipv6 dhcp-server" on page 2500
"clear ipv6 dhcp binding" on page 2501
"clear ipv6 dhcp client" on page 2503
"dns-server (DHCPv6)" on page 2504
"domain-name (DHCPv6)" on page 2506
"ip dhcp-relay agent-option
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
DHCP for IPv6
(DHCPv6)
Commands
DHCPv6 Feature Overview and
subscriber-id-auto-mac" on page 2507
"Getting Started
Guide.
2493