Http-Enable - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
HTTP ENABLE

http-enable

Overview This command is used to enable GUI access to a guest node. When http-enable is
configured the port number is set to its default of 80. If the guest node is using a
different port for HTTP, you can configure this using the port <PORTNO> attribute.
This command is used to inform the GUI that this device has an HTTP interface at
the specified port number so that a suitable URL can be provided to the user.
Use the no variant of this command to disable HTTP.
http-enable [port <port-number>]
Syntax
no http-enable
http-enable is off. 
Default
If http-enable is selected without a port parameter the port number will default to
80.
Mode ATMF Guest Configuration Mode
Example 1 To enable HTTP access to a guest node on port 80 (the default), use the following
commands:
node1#
node1(config)#atmf guest-class Camera
node1(config-atmf-guest)#http-enable
node1(config-atmf-guest)#
Example 2 To enable HTTP access to a guest node on port 400, use the following commands:
node1#
node1(config)#atmf guest-class Camera
node1(config-atmf-guest)#http-enable port 400
node1(config-atmf-guest)#
Example 3 To disable HTTP access to a guest node, use the following commands:
node1#
node1(config)#atmf guest-class Camera
node1(config-atmf-guest)#no http-enable
node1(config-atmf-guest)#
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
port
TCP port number.
<port-number>
The port number to be configured.
conf t
conf t
conf t
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
2327