Probe Type - Allied Telesis x510-28GTX Command Reference Manual

D H C
YNAMIC OST ONFIGURATION

PROBE TYPE

probe type
Overview Use this command to set the probe type for a DHCP pool. The probe type specifies
how the DHCP server checks whether an IP address is being used by other hosts,
referred to as lease probing. If arp is specified, the server sends an ARP request to
determine if an address is in use. If ping is specified, the server will send an ICMP
Echo Request (ping).
The no variant of this command sets the probe type to the default setting, ping.
probe type {arp|ping}
Syntax
no probe type
Default The default probe type is ping.
Mode DHCP Pool Configuration
To set the probe type to arp for the pool P2, use the commands:
Examples
awplus#
awplus(config)#
awplus(dhcp-config)#
To set the probe type for the pool P2 to the default, ping, use the commands:
awplus#
awplus(config)#
awplus(dhcp-config)#
Related ip dhcp pool
Commands
probe enable
probe packets
probe timeout
show ip dhcp pool
C613-50170-01 Rev B
P (DHCP) C
ROTOCOL OMMANDS
Parameter
arp
ping
configure terminal
ip dhcp pool P2
configure terminal
ip dhcp pool P2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Probe using ARP.
Probe using ping.
probe type arp
no probe type
2469