Type Atmf Node - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

TYPE ATMF NODE

type atmf node
Overview This command configures a trigger to be activated at an AMF node join event or
leave event.
type atmf node {join|leave}
Syntax
Mode Trigger Configuration
CAUTION
Example 1 To configure trigger 5 to activate at an AMF node leave event, use the following
commands. In this example the command is entered on node-1:
node1(config)#
node1(config-trigger)
Example 2 The following commands will configure trigger 5 to activate if an AMF node join
event occurs on any node within the working set:
node1#
This command returns the following display:
Note that the running the above command changes the prompt from the name of
the local node, to the name of the AMF-Network followed, in square brackets, by
the number of member nodes in the working set.
AMF-Net[3]#
AMF-Net[3](config)#
AMF-Net[3](config-trigger)#
AMF-Net[3](config-trigger)#
AMF-Net[3](config-trigger)#
Enter the name of the script to run at the trigger event.
AMF-Net[3](config-trigger)#
AMF-Net[3](config-trigger)#
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
join
AMF node join event.
leave
AMF node leave event.
: Only configure this trigger on one device because it is a network wide event.
trigger 5
atmf working-set group all
====================
node1, node2, node3:
====================

Working set join
conf t
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
type atmf node leave
trigger 5
type atmf node leave
description "E-mail on AMF Exit"
active
script 1 email_me.scp
end
2426