How To Export Trace Data And Numerical Results - R&S FSW-K7 User Manual

®
R&S FSW-K7
●
●
●
●
10. Start a new sweep with the defined settings.
In multistandard mode you may want to stop the continuous measurement mode
by the Sequencer and perform a single data acquisition:
a) Select the Sequencer icon ( ) from the toolbar.
b) Set the Sequencer state to "OFF".
c) Press the RUN SINGLE key.
11. Optionally, export the trace data of the demodulated signal to a file.
a) In the "Traces" tab of the "Analysis" dialog box, switch to the "Trace Export"
b) Select "Export Trace to ASCII File".
c) Define a file name and storage location and select "OK".

8.1 How to Export Trace Data and Numerical Results

The measured trace data and numerical measurement results in tables can be expor-
ted to an ASCII file. For each sweep point the measured trace position and value are
output.
The file is stored with a .DAT or .CSV extension. For details on the storage format see
Chapter 11.7.5, "Reference: ASCII File Export
For the results of a Spectrum Emission Mask (SEM) or Spurious Emissions measure-
ment, special file export functions are available, see
@y.link.required='true'
To export trace data and table results
1. Select TRACE > "Trace Config" > "Trace/Data Ex/Import" tab.
2. Select "Export all Traces and all Table Results" to export all available measure-
ment result data for the current application, or select a specific "Trace to Export".
3. Optionally, select the "Include Instrument & Measurement Settings" option to insert
additional information in the export file header.
4. Select the "Export Trace to ASCII file" button.
User Manual 1173.9240.02 ─ 23
How to Perform Measurements in the Analog Demodulation Application
Configure a trace to display the average over a series of sweeps (on the
"Trace" tab; if necessary, increase the "Sweep Count" in the "Data Acquisition"
settings).
Configure markers and delta markers to determine deviations and offsets within
the demodulated signal (on the "Marker" tab).
Use special marker functions to calculate phase noise or an n dB down band-
width (on the "Marker Config" tab).
Configure a limit check to detect excessive deviations (on the "Lines" tab).
tab.
(SEM) and
PRODERROR! Linktarget doesn't exist but @y.link.required='true'
How to Export Trace Data and Numerical Results
Format", on page 317.
PRODERROR! Linktarget doesn't exist but
(Spurious).
168