R&S FSW-K7 User Manual page 300

®
R&S FSW-K7
11.6.1 General Window Commands
The following commands are required to configure general window layout, independent
of the application.
Note that the suffix <n> always refers to the window in the currently selected measure-
ment channel (see
DISPlay:FORMat
DISPlay[:WINDow<n>]:SIZE
DISPlay:FORMat <Format>
This command determines which tab is displayed.
Parameters:
<Format>
Example:
DISPlay[:WINDow<n>]:SIZE <Size>
This command maximizes the size of the selected result display window temporarily.
To change the size of several windows on the screen permanently, use the LAY:SPL
command (see
Suffix:
<n>
Parameters:
<Size>
Example:
11.6.2 Working with Windows in the Display
The following commands are required to change the evaluation type and rearrange the
screen layout for a measurement channel as you do using the SmartGrid in manual
operation. Since the available evaluation types depend on the selected application,
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
INSTrument[:SELect]
........................................................................................................... 300
........................................................................................... 300
SPLit
Displays the MultiView tab with an overview of all active chan-
nels
SINGle
Displays the measurement channel that was previously focused.
*RST: SING
DISP:FORM SPL
on page 304).
LAYout:SPLitter
.
Window
LARGe
Maximizes the selected window to full screen.
Other windows are still active in the background.
SMALl
Reduces the size of the selected window to its original size.
If more than one measurement window was displayed originally,
these are visible again.
*RST: SMALl
DISP:WIND2:SIZE LARG
Configuring the Result Display
on page 186).
300