Table of Contents
Advertisement
®
R&S
FSW-K7
Suffix:
<n>
<k>
Parameters:
<Unit>
Manual operation:
CALCulate<n>:LIMit<k>:UPPer[:DATA] <LimitLinePoints>
This command defines the vertical definition points of an upper limit line.
Suffix:
<n>
<k>
Parameters:
<LimitLinePoints>
Manual operation:
CALCulate<n>:LIMit<k>:UPPer:MARGin <Margin>
This command defines an area around an upper limit line where limit check violations
are still tolerated.
Suffix:
<n>
<k>
Parameters:
<Margin>
Manual operation:
CALCulate<n>:LIMit<k>:UPPer:MODE <Mode>
This command selects the vertical limit line scaling.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.
irrelevant
Limit line
If you select dB as the limit line unit, the command automatically
turns the limit line into a relative limit line.
*RST:
DBM
See
"Y-Axis"
on page 159
.
irrelevant
Limit line
Variable number of level values.
Note that the number of vertical values has to be the same as
the number of horizontal values set with
LIMit<k>:CONTrol[:DATA]. If not, the R&S FSW either adds
missing values or ignores surplus values.
The unit depends on
on page 360.
*RST:
Limit line state is OFF
See
"Data points"
on page 159
.
irrelevant
Limit line
numeric value
*RST:
0
Default unit: dB
See
"Margin"
on page 159
CALCulate<n>:
CALCulate<n>:LIMit<k>:UNIT
Analyzing Results
361
Advertisement
Chapters
Table of Contents
