R&S FSW-K7 User Manual page 214

®
R&S FSW-K7
Example:
Manual operation:
INPut:DIQ:RANGe[:UPPer]:AUTO <State>
If enabled, the digital input full scale level is automatically set to the value provided by
the connected device (if available).
This command is only available if the optional Digital Baseband interface is installed.
Parameters:
<State>
Manual operation:
INPut:DIQ:RANGe:COUPling <State>
If enabled, the reference level for digital input is adjusted to the full scale level automat-
ically if the full scale level changes.
This command is only available if the optional Digital Baseband Interface is installed.
Parameters:
<State>
Manual operation:
INPut:DIQ:RANGe[:UPPer] <Level>
Defines or queries the "Full Scale Level", i.e. the level that corresponds to an I/Q sam-
ple with the magnitude "1".
This command is only available if the optional Digital Baseband Interface is installed.
Parameters:
<Level>
Manual operation:
INPut:DIQ:RANGe[:UPPer]:UNIT <Unit>
Defines the unit of the full scale level (see
bility of units depends on the measurement application you are using.
This command is only available if the optional Digital Baseband Interface is installed.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
INP:DIQ:CDEV?
Result:
1,SMW200A,101190,BBMM 1 OUT,
100000000,200000000,Passed,Passed,1,1.#QNAN
See "Connected Instrument"
ON | OFF | 1 | 0
*RST: 0
See "Full Scale Level"
ON | OFF | 1 | 0
*RST: 0
See "Adjust Reference Level to Full Scale Level"
<numeric value>
Range: 1 μV to 7.071 V
*RST: 1 V
See "Full Scale Level"
"Full Scale Level"
Configuring the Measurement
on page 67
on page 67
on page 67
on page 67). The availa-
on page 67
214