Trigger Input And Output Settings; Slope; Trigger Holdoff - R&S FSW-K7 User Manual

®
R&S FSW-K7
"AC"
Remote command:
TRIGger[:SEQuence]:OSCilloscope:COUPling

Slope

For all trigger sources except time, you can define whether triggering occurs when the
signal rises to the trigger level or falls down to it.
When using the optional 2 GHz bandwidth extension (R&S FSW-B2000) with an IF
power trigger, only rising slopes can be detected.
(For details see the R&S FSW I/Q Analyzer and I/Q Input User Manual.)
Remote command:
TRIGger[:SEQuence]:SLOPe

Trigger Holdoff

Defines the minimum time (in seconds) that must pass between two trigger events.
Trigger events that occur during the holdoff time are ignored.
Remote command:
TRIGger[:SEQuence]:IFPower:HOLDoff

5.4.2 Trigger Input and Output Settings

Access: "Overview" > "Trigger" > "Trigger In/Out" tab
Trigger
Trigger 2/3
Defines the usage of the variable TRIGGER INPUT/OUTPUT connectors, where:
"Trigger 2": TRIGGER INPUT/OUTPUT connector on the front panel
"Trigger 3": TRIGGER 3 INPUT/ OUTPUT connector on the rear panel
(Trigger 1 is INPUT only.)
Note: Providing trigger signals as output is described in detail in the R&S FSW User
Manual.
"Input"
"Output"
User Manual 1173.9240.02 ─ 23
Connection through capacitor, removes unwanted DC and very low-
frequency components.
2/3...................................................................................................................103
└ Output Type.................................................................................................. 104
└ Level................................................................................................... 104
└ Pulse Length.......................................................................................104
└ Send Trigger....................................................................................... 104
The signal at the connector is used as an external trigger source by
the R&S FSW. Trigger input parameters are available in the "Trigger"
dialog box.
The R&S FSW sends a trigger signal to the output connector to be
used by connected devices.
Further trigger parameters are available for the connector.
Note: For offline AF or RF triggers, no output signal is provided.
on page 209
on page 262
on page 258
Configuration
Trigger Configuration
103