R&S FSW-K7 User Manual page 356

®
R&S FSW-K7
Parameters:
<LimitLinePoints>
Manual operation:
CALCulate<n>:LIMit<k>:CONTrol:DOMain <SpanSetting>
This command selects the domain of the limit line.
Suffix:
<n>
<k>
Parameters:
<SpanSetting>
Manual operation:
CALCulate<n>:LIMit<k>:CONTrol:MODE <Mode>
This command selects the horizontal limit line scaling.
Suffix:
<n>
<k>
Parameters:
<Mode>
CALCulate<n>:LIMit<k>:CONTrol:OFFSet <Offset>
This command defines an offset for a complete limit line.
Compared to shifting the limit line, an offset does not actually change the limit line defi-
nition points.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
Variable number of x-axis values.
Note that the number of horizontal values has to be the same as
the number of vertical values set with
LIMit<k>:LOWer[:DATA]
UPPer[:DATA]. If not, the R&S FSW either adds missing val-
ues or ignores surplus values.
The unit is Hz or s.
*RST: -
See "Data points" on page 159
.
irrelevant
Limit line
FREQuency | TIME
*RST: FREQuency
See "X-Axis" on page 159
.
irrelevant
Limit line
ABSolute
Limit line is defined by absolute physical values (Hz or s).
RELative
Limit line is defined by relative values related to the center fre-
quency (frequency domain) or the left diagram border (time
domain).
*RST: ABSolute
Analyzing Results
CALCulate<n>:
or
CALCulate<n>:LIMit<k>:
356