R&S FSW-K7 User Manual page 50

®
R&S FSW-K7
2. Trigger
See
3. Data Acquisition
See
4. Demod/Display
See
5. Demodulation Settings
See
6. Analysis
See
7. (Optionally:) Outputs
See
To configure settings
► Select any button in the "Overview" to open the corresponding dialog box.
Select a setting in the channel bar (at the top of the measurement channel tab) to
change a specific setting.
Preset Channel
Select the Channel button in the lower lefthand corner of the "Overview" to restore all
measurement settings in the current channel to their default values.
Do not confuse the Channel button with the PRESET key, which restores the entire
instrument to its default values and thus closes all measurement channels on the
R&S FSW (except for the default Spectrum application channel)!
Remote command:
SYSTem:PRESet:CHANnel[:EXEC]
Setup Standard
Opens a file selection dialog box to select a predefined setup file. See
dard"
Specifics for
The measurement channel may contain several windows for different results. Thus, the
settings indicated in the "Overview" and configured in the dialog boxes vary depending
on the selected window.
Select an active window from the "Specifics for" selection list that is displayed in the
"Overview" and in all window-specific configuration dialog boxes.
The "Overview" and dialog boxes are updated to indicate the settings for the selected
window.
User Manual 1173.9240.02 ─ 23
Chapter 5.4, "Trigger
Chapter 5.5, "Data Acquisition",
Chapter 5.6, "Demodulation
Chapter 5.7, "Demodulation",
Chapter 6, "Analysis",
Chapter 5.8.1, "Output
on page 51.
Configuration", on page 96
on page 105
Display", on page 109
on page 110
on page 133
Settings", on page 126
on page 186
Configuration
Configuration Overview
"Setup Stan-
50