R&S FSW-K7 User Manual page 311

®
R&S FSW-K7
Parameters:
<Separator>
Example:
Manual operation:
FORMat:DEXPort:HEADer <State>
If enabled, additional instrument and measurement settings are included in the header
of the export file for result data. If disabled, only the pure result data from the selected
traces and tables is exported.
See
Parameters:
<State>
Manual operation:
FORMat:DEXPort:TRACes <Selection>
This command selects the data to be included in a data export file (see
STORe<n>:TRACe
Parameters:
<Selection>
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
COMMa
Uses a comma as decimal separator, e.g. 4,05.
POINt
Uses a point as decimal separator, e.g. 4.05.
*RST:
FORM:DEXP:DSEP POIN
Sets the decimal point as separator.
See
See
Chapter 11.7.5, "Reference: ASCII File Export
ON | OFF | 0 | 1
*RST:
See
on page 310).
SINGle
Only a single trace is selected for export, namely the one speci-
fied by the
ALL
Selects all active traces and result tables (e.g. Result Summary,
marker peak list etc.) in the current application for export to an
ASCII file.
The <trace> parameter for the
command is ignored.
*RST:
See
*RST has no effect on the decimal separator.
Default is POINt.
"Decimal Separator" on page 137
"Exporting the Peak List"
1
"Include Instrument Measurement Settings"
MMEMory:STORe<n>:TRACe
SINGle
"Export all Traces and all Table Results"
Retrieving Results
on page 152
Format", on page 317 for details.
on page 137
MMEMory:
command.
MMEMory:STORe<n>:TRACe
on page 137
311