R&S FSW-K7 User Manual page 198

®
R&S FSW-K7
Manual operation:
[SENSe:]MIXer:LOSS:TABLe[:LOW] <FileName>
This command defines the file name of the conversion loss table to be used for the low
(first) range.
Parameters:
<FileName>
Example:
Manual operation:
[SENSe:]MIXer:LOSS[:LOW] <Average>
This command defines the average conversion loss to be used for the entire low (first)
range.
Parameters:
<Average>
Example:
Manual operation:
[SENSe:]MIXer:PORTs <PortType>
This command specifies whether the mixer is a 2-port or 3-port type.
Parameters:
<PortType>
Example:
Manual operation:
[SENSe:]MIXer:RFOVerrange[:STATe] <State>
If enabled, the band limits are extended beyond "RF Start" and "RF Stop" due to the
capabilities of the used harmonics.
Parameters:
<State>
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
See "Conversion loss"
String containing the path and name of the file.
MIX:LOSS:TABL 'mix_1_4'
Specifies the conversion loss table mix_1_4.
See "Conversion loss"
numeric value
Range: 0 to 100
*RST: 24.0 dB
Default unit: dB
MIX:LOSS 20dB
See "Conversion loss"
2 | 3
*RST: 2
MIX:PORT 3
See "Mixer Type" on page 57
ON | OFF | 1 | 0
*RST: 0
See "RF Overrange"
Configuring the Measurement
on page 58
on page 58
on page 58
on page 57
198