R&S FSW-K7 User Manual page 321

®
R&S FSW-K7
Manual operation:
CALCulate<n>:MARKer<m>:TRACe <Trace>
This command selects the trace the marker is positioned on.
Note that the corresponding trace must have a trace mode other than "Blank".
If necessary, the command activates the marker first.
Suffix:
<n>
<m>
Parameters:
<Trace>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:X <Position>
This command moves a marker to a particular coordinate on the x-axis.
If necessary, the command activates the marker.
If the marker has been used as a delta marker, the command turns it into a normal
marker.
Suffix:
<m>
<n>
Parameters:
<Position>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
See "Marker State" on page 139
See "Marker Type" on page 140
See "Select Marker"
.
Window
Marker
1 to 6
Trace number the marker is assigned to.
CALC:MARK3:TRAC 2
Assigns marker 3 to trace 2.
See "Assigning the Marker to a Trace"
.
Marker (query: 1 to 16)
Window
Numeric value that defines the marker position on the x-axis.
The unit is either Hz (frequency domain) or s (time domain) or
dB (statistics).
Range: The range depends on the current x-axis range.
CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
See "Marker Table" on page 22
See "Marker Peak List"
See "Marker Position (X-value)"
on page 144
on page 141
on page 23
on page 140
Analyzing Results
321