Rf Power; Power Sensor; Trigger Level - R&S FSW-K7 User Manual

®
R&S FSW-K7
RF Power ← Trigger Source
Defines triggering of the measurement via signals which are outside the displayed
measurement range.
For this purpose, the instrument uses a level detector at the first intermediate fre-
quency.
The input signal must be in the frequency range between 500 MHz and 8 GHz.
The resulting trigger level at the RF input depends on the RF attenuation and preampli-
fication. For details on available trigger levels, see the instrument's data sheet.
Note: If the input signal contains frequencies outside of this range (e.g. for fullspan
measurements), the sweep may be aborted. A message indicating the allowed input
frequencies is displayed in the status bar.
A "Trigger Offset", "Trigger Polarity" and "Trigger Holdoff" (to improve the trigger stabil-
ity) can be defined for the RF trigger, but no "Hysteresis".
This trigger source is not available for input from the optional Digital Baseband Inter-
face or the optional Analog Baseband Interface . If the trigger source "RF Power" is
selected and digital I/Q or analog baseband input is activated, the trigger source is
automatically switched to "Free Run".
Remote command:
TRIG:SOUR RFP, see
Power Sensor ← Trigger Source
Uses an external power sensor as a trigger source. This option is only available if a
power sensor is connected and configured.
Note: For Rohde & Schwarz power sensors, the "Gate Mode" Lvl is not supported. The
signal sent by these sensors merely reflects the instant the level is first exceeded,
rather than a time period. However, only time periods can be used for gating in level
mode. Thus, the trigger impulse from the sensors is not long enough for a fully gated
measurement; the measurement cannot be completed.
Remote command:
TRIG:SOUR PSE, see

Trigger Level

Defines the trigger level for the specified trigger source.
For details on supported trigger levels, see the data sheet.
Remote command:
TRIGger[:SEQuence]:LEVel:IFPower
TRIGger[:SEQuence]:LEVel:IQPower
TRIGger[:SEQuence]:LEVel[:EXTernal<port>]
For analog baseband or digital baseband input only:
TRIGger[:SEQuence]:LEVel:BBPower
TRIGger[:SEQuence]:LEVel:RFPower
TRIGger[:SEQuence]:LEVel:AM:RELative
TRIGger[:SEQuence]:LEVel:AM[:ABSolute]
TRIGger[:SEQuence]:LEVel:FM
TRIGger[:SEQuence]:LEVel:PM
User Manual 1173.9240.02 ─ 23
TRIGger[:SEQuence]:SOURce
TRIGger[:SEQuence]:SOURce
on page 259
on page 259
on page 258
on page 260
on page 261
on page 261
Configuration
Trigger Configuration
on page 262
on page 262
on page 259
on page 260
on page 261
101