R&S FSW-K7 User Manual page 230

®
R&S FSW-K7
SOURce:EXTernal:FREQuency[:FACTor]:NUMerator
SOURce:EXTernal:FREQuency:OFFSet
SOURce:EXTernal:POWer[:LEVel]
SOURce:EXTernal[:STATe]
SOURce:POWer[:LEVel][:IMMediate]:OFFSet
SOURce:EXTernal:FREQuency <Frequency>
This command defines a fixed source frequency for the external generator.
Parameters:
<Frequency>
Example:
Manual operation:
SOURce:EXTernal:FREQuency:COUPling[:STATe] <State>
This command couples the frequency of the external generator output to the
R&S FSW.
Parameters:
<State>
Example:
Manual operation:
SOURce:EXTernal:FREQuency[:FACTor]:DENominator <Value>
This command defines the denominator of the factor with which the analyzer frequency
is multiplied in order to obtain the transmit frequency of the selected generator.
Select the multiplication factor such that the frequency range of the generator is not
exceeded if the following formula is applied to the start and stop frequency of the ana-
lyzer:
Source
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
............................................................................................ 232
Source frequency of the external generator.
*RST:
SOUR:EXT:FREQ 10MHz
See "(Manual) Source Frequency"
ON | OFF | 0 | 1
ON | 1
Default setting: a series of frequencies is defined (one for each
sweep point), based on the current frequency at the RF input of
the R&S FSW; the RF frequency range covers the currently
defined span of the R&S FSW (unless limited by the range of the
signal generator)
OFF | 0
The generator uses a single fixed frequency, defined by
SOURce:EXTernal:FREQuency.
*RST:
SOUR:EXT:FREQ:COUP ON
See "Source Frequency Coupling"
Numerator
  
Freq RF Offset
Denominato r
........................................................231
.......................................................................... 231
.................................................................................. 232
...................................................................232
1100050000
1
Configuring the Measurement
on page 75
on page 75
230