R&S FSW-K7 User Manual page 323

®
R&S FSW-K7
Example:
Usage:
CALCulate<n>:DELTamarker<m>:LINK <State>
This command links delta marker <m> to marker 1.
If you change the horizontal position (x-value) of marker 1, delta marker <m> changes
its horizontal position to the same value.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:DELTamarker<m>:LINK:TO:MARKer<m> <State>
This command links delta marker <m1> to any active normal marker <m2>.
If you change the horizontal position of marker <m2>, delta marker <m1> changes its
horizontal position to the same value.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:DELTamarker<m>:MODE <Mode>
This command defines whether the position of a delta marker is provided as an abso-
lute value or relative to a reference marker.
Note that when the position of a delta marker is queried, the result is always an abso-
lute value (see
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
CALC:DELT:AOFF
Turns off all delta markers.
Event
.
Window
Marker
ON | OFF | 1 | 0
*RST: 0
CALC:DELT2:LINK ON
See "Linking to Another Marker"
.
Window
Marker
ON | OFF | 1 | 0
*RST: 0
CALC:DELT4:LINK:TO:MARK2 ON
Links the delta marker 4 to the marker 2.
See "Linking to Another Marker"
CALCulate<n>:DELTamarker<m>:X
Analyzing Results
on page 140
on page 140
on page 325)!
323