R&S FSW-K7 User Manual page 279

®
R&S FSW-K7
11.4.8.6 Scaling for AF Evaluation
These settings are only available for AF evaluations.
Useful commands described elsewhere:
●
[SENSe:]ADJust:SCALe[:Y]:AUTO[:CONTinuous]
●
[SENSe:]ADEMod<n>:AF:COUPling
●
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RPOSition
●
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing
Specific commands:
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RVALue
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RVALue <Value>
This command defines the reference value assigned to the reference position in the
specified window. Separate reference values are maintained for the various displays.
Suffix:
<t>
Parameters:
<Value>
Example:
Manual operation:
11.4.8.7 Scaling for RF Evaluation
These commands are required for RF evaluations and the result summary.
●
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RPOSition
●
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing
●
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
●
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:MODE
11.4.8.8 Units
The units define how the demodulated data is displayed.
UNIT<n>:ANGLe
UNIT<n>:THD
UNIT<n>:ANGLe <Unit>
This command selects the unit for angles (for PM display, <n> is irrelevant).
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.
irrelevant
*RST: AM time domain: 0 PCT; FM time domain: 0 Hz;
PM time domain: 0 rad; AM spectrum: 100 PCT;
FM spectrum: 250 kHz; PM spectrum: 10 rad;
DISP:TRAC:Y:RVAL 0
Sets the value assigned to the reference position to 0 Hz
See "Reference Value"
............................................................................................................279
................................................................................................................280
Configuring the Measurement
on page 286
on page 267
on page 251
...................................................... 279
on page 121
on page 251
on page 249
on page 249
on page 250
on page 250
279