Digital I/Q; Fm / Am / Pm / Rf; Time - R&S FSW-K7 User Manual

®
R&S FSW-K7
For more information on the Digital Baseband Interface or the Analog Baseband Inter-
face, see the R&S FSW I/Q Analyzer and I/Q Input User Manual.
Remote command:
TRIG:SOUR BBP, see
Digital I/Q ← Trigger Source
For applications that process I/Q data, such as the I/Q Analyzer or optional applica-
tions, and only if the optional Digital Baseband Interface is available:
Defines triggering of the measurement directly via the LVDS connector. In the selection
list you must specify which general purpose bit (GP0 to GP5) will provide the trigger
data.
Note:
If the Digital I/Q enhanced mode is used, i.e. the connected device supports transfer
rates up to 200 Msps, only the general purpose bits GP0 and GP1 are available as a
Digital I/Q trigger source.
The following table describes the assignment of the general purpose bits to the LVDS
connector pins.
(For details on the LVDS connector, see the R&S FSW I/Q Analyzer User Manual.)
Table 5-1: Assignment of general purpose bits to LVDS connector pins
Bit
GP0
GP1
GP2
GP3
GP4
GP5
*)
: not available for Digital I/Q enhanced mode
Remote command:
TRIG:SOUR GP0, see
FM / AM / PM / RF (Offline) ← Trigger Source
Triggers when the demodulated input signal exceeds the trigger level.
Remote command:
TRIGger[:SEQuence]:SOURce
Time ← Trigger Source
Triggers in a specified repetition interval.
Remote command:
TRIG:SOUR TIME, see
User Manual 1173.9240.02 ─ 23
TRIGger[:SEQuence]:SOURce
LVDS pin
SDATA4_P - Trigger1
SDATA4_P - Trigger2
SDATA0_P - Reserve1
*)
SDATA4_P - Reserve2
*)
*) SDATA0_P - Marker1
SDATA4_P - Marker2
*)
TRIGger[:SEQuence]:SOURce
TRIGger[:SEQuence]:SOURce
on page 262
Configuration
Trigger Configuration
on page 262
on page 262
on page 262
100