R&S FSW-K7 User Manual page 251

®
R&S FSW-K7
Manual operation:
DISPlay[:WINDow<n>]:TRACe<t>:Y:SPACing <ScalingType>
This command selects the scaling of the y-axis (for all traces, <t> is irrelevant).
For AF spectrum displays, only the parameters "LINear" and "LOGarithmic" are permit-
ted.
Suffix:
<n>
<t>
Parameters:
<ScalingType>
Example:
Manual operation:
11.4.6 Configuring Data Acquisition
The following remote commands are required to configure which data is to be acquired
and then demodulated in a remote environment.
MSRA/MSRT operating mode
In MSRA/MSRT operating mode, only the MSRA/MSRT Master channel actually cap-
tures data from the input signal. The data acquisition commands for the Analog
Demodulation application in MSRA/MSRT mode define the analysis interval.
For details on the MSRA operating mode see the R&S FSW MSRA User Manual. For
details on the MSRT operating mode see the R&S FSW Realtime Spectrum Applica-
tion and MSRT Operating Mode User Manual.
[SENSe:]ADEMod<n>:MTIMe
[SENSe:]ADEMod<n>:RLENgth?
[SENSe:]ADEMod<n>:SET
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
See "Reference Position"
See "Reference Value Position"
See "Ref Level Position"
.
Window
Trace
LOGarithmic
Logarithmic scaling.
LINear
Linear scaling in %.
LDB
Linear scaling in the specified unit.
PERCent
Linear scaling in %.
*RST: LOGarithmic
DISP:TRAC:Y:SPAC LIN
Selects linear scaling in %.
See "Deviation" on page 122
See "Scaling" on page 123
......................................................................................... 252
.....................................................................................252
............................................................................................. 252
Configuring the Measurement
on page 78
on page 121
on page 123
251