R&S FSW-K7 User Manual page 218

®
R&S FSW-K7
Suffix:
<p>
Return values:
<State>
Usage:
[SENSe:]PROBe<p>:SETup:TYPE?
Queries the type of the probe.
Suffix:
<p>
Return values:
<Type>
Usage:
11.4.2.7 Working with Power Sensors
The following commands describe how to work with power sensors.
These commands require the use of a Rohde & Schwarz power sensor. For a list of
supported sensors, see the data sheet.
● Configuring Power
● Configuring Power Sensor
● Triggering with Power
Configuring Power Sensors
SYSTem:COMMunicate:RDEVice:PMETer<p>:CONFigure:AUTO[:STATe]
SYSTem:COMMunicate:RDEVice:PMETer:COUNt?
SYSTem:COMMunicate:RDEVice:PMETer<p>:DEFine
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.
1 | 2 | 3
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF (currently not supported; use "1" with RF Input Connec-
tor setting "Baseband Input I")
DETected | NDETected
*RST: NDETected
Query only
.
1 | 2 | 3
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF (currently not supported; use "1" with RF Input Connec-
tor setting "Baseband Input I")
String containing one of the following values:
– None (no probe detected)
– active differential
– active single-ended
Query only
Sensors.................................................................................. 218
Measurements........................................................... 220
Sensors............................................................................. 227
Configuring the Measurement
......................... 219
..........................................................219
......................................................219
218