R&S FSW-K7 User Manual page 194

®
R&S FSW-K7
[SENSe:]MIXer:THReshold <Value>
This command defines the maximum permissible level difference between test sweep
and reference sweep to be corrected during automatic comparison (see
]MIXer:SIGNal
Parameters:
<Value>
Example:
Manual operation:
Mixer Settings
The following commands are required to configure the band and specific mixer set-
tings.
[SENSe:]MIXer:FREQuency:HANDover
[SENSe:]MIXer:FREQuency:STARt?
[SENSe:]MIXer:FREQuency:STOP?
[SENSe:]MIXer:HARMonic:BAND:PRESet
[SENSe:]MIXer:HARMonic:BAND
[SENSe:]MIXer:HARMonic:HIGH:STATe
[SENSe:]MIXer:HARMonic:HIGH[:VALue]
[SENSe:]MIXer:HARMonic:TYPE
[SENSe:]MIXer:HARMonic[:LOW]
[SENSe:]MIXer:LOSS:HIGH
[SENSe:]MIXer:LOSS:TABLe:HIGH
[SENSe:]MIXer:LOSS:TABLe[:LOW]
[SENSe:]MIXer:LOSS[:LOW]
[SENSe:]MIXer:PORTs
[SENSe:]MIXer:RFOVerrange[:STATe]
[SENSe:]MIXer:FREQuency:HANDover <Frequency>
This command defines the frequency at which the mixer switches from one range to
the next (if two different ranges are selected). The handover frequency for each band
can be selected freely within the overlapping frequency range.
This command is only available if the external mixer is active (see
STATe]
Parameters:
<Frequency>
Example:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
on page 193).
<numeric value>
Range:
*RST:
MIX:PORT 3
See "Auto ID Threshold"
.................................................................................... 195
.....................................................................................197
....................................................................................197
............................................................................................197
...........................................................................................198
...................................................................................................198
on page 192).
numeric value
MIX ON
Activates the external mixer.
MIX:FREQ:HAND 78.0299GHz
Sets the handover frequency to 78.0299 GHz.
0.1 dB to 100 dB
10 dB
on page 60
........................................................................... 194
................................................................................195
................................................................................ 195
........................................................................195
.......................................................................... 196
........................................................................ 196
................................................................................. 197
................................................................................198
............................................................................ 198
Configuring the Measurement
[SENSe:
[SENSe:]MIXer[:
194