Radio Frequency Input; Radio Frequency State - R&S FSW-K7 User Manual

®
R&S FSW-K7
The default input source for the R&S FSW is "Radio Frequency", i.e. the signal at the
RF INPUT connector of the R&S FSW. If no additional options are installed, this is the
only available input source.
Since the Digital I/Q input and the Analog Baseband input use the same digital signal
path, both cannot be used simultaneously. When one is activated, established connec-
tions for the other are disconnected. When the second input is deactivated, connec-
tions to the first are re-established. This may cause a short delay in data transfer after
switching the input source.
External mixers are not supported in MSRA/MSRT mode.
● Radio Frequency
● External Mixer
● Digital I/Q Input
● Analog Baseband Input
● Probe
● External Generator Control
● Settings for 2 GHz Bandwidth Extension (R&S
5.3.1.1

Radio Frequency Input

Access: "Overview" > "Input/Frontend" > "Input Source" > "Radio Frequency"
Radio Frequency
Input
Direct
High-Pass Filter 1...3
YIG-Preselector.............................................................................................................55
Input

Radio Frequency State

Activates input from the RF INPUT connector.
User Manual 1173.9240.02 ─ 23
Input............................................................................................53
Settings........................................................................................... 55
Settings......................................................................................... 65
Settings.............................................................................68
Settings.........................................................................................................70
State................................................................................................. 53
Coupling............................................................................................................... 54
Path.................................................................................................................... 54
GHz............................................................................................ 54
Connector.............................................................................................................55
Settings....................................................................... 71
FSW-B2000).................................79
Configuration
Input and Frontend Settings
53