R&S FSW-K7 User Manual page 266

®
R&S FSW-K7
OUTPut:TRIGger<port>:OTYPe <OutputType>
This command selects the type of signal generated at the trigger output.
Note: For offline AF or RF triggers, no output signal is provided.
Suffix:
<port>
Parameters:
<OutputType>
Manual operation:
OUTPut:TRIGger<port>:PULSe:IMMediate
This command generates a pulse at the trigger output.
Suffix:
<port>
Usage:
Manual operation:
OUTPut:TRIGger<port>:PULSe:LENGth <Length>
This command defines the length of the pulse generated at the trigger output.
Suffix:
<port>
Parameters:
<Length>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
DEVice
Sends a trigger signal when the R&S FSW has triggered inter-
nally.
TARMed
Sends a trigger signal when the trigger is armed and ready for
an external trigger event.
UDEFined
Sends a user defined trigger signal. For more information see
OUTPut:TRIGger<port>:LEVel.
*RST: DEVice
See "Output Type" on page 104
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
Event
See "Send Trigger" on page 104
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
Pulse length in seconds.
OUTP:TRIG2:PULS:LENG 0.02
See "Pulse Length" on page 104
Configuring the Measurement
266