R&S FSW-K7 User Manual page 242

®
R&S FSW-K7
11.4.4 Frequency Settings
[SENSe:]FREQuency:CENTer
[SENSe:]FREQuency:CENTer:STEP
[SENSe:]FREQuency:CENTer:STEP:LINK
[SENSe:]FREQuency:CENTer:STEP:LINK:FACTor
[SENSe:]FREQuency:CENTer <Frequency>
This command defines the center frequency.
Parameters:
<Frequency>
Example:
Manual operation:
[SENSe:]FREQuency:CENTer:STEP <StepSize>
This command defines the center frequency step size.
You can increase or decrease the center frequency quickly in fixed steps using the
SENS:FREQ UP AND SENS:FREQ DOWN commands, see
CENTer
Parameters:
<StepSize>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
.........................................................................................242
The allowed range and f
UP
Increases the center frequency by the step defined using the
[SENSe:]FREQuency:CENTer:STEP
DOWN
Decreases the center frequency by the step defined using the
[SENSe:]FREQuency:CENTer:STEP
*RST:
Default unit: Hz
FREQ:CENT 100 MHz
FREQ:CENT:STEP 10 MHz
FREQ:CENT UP
Sets the center frequency to 110 MHz.
See "Center Frequency"
See "Center frequency"
on page 242.
f is specified in the data sheet.
max
Range:
*RST:
Default unit: Hz
FREQ:CENT 100 MHz
FREQ:CENT:STEP 10 MHz
FREQ:CENT UP
Sets the center frequency to 110 MHz.
See "Center Frequency Stepsize"
............................................................................... 242
....................................................................... 243
........................................................... 243
is specified in the data sheet.
max
fmax/2
on page 70
on page 95
1 to fMAX
0.1 x span
Configuring the Measurement
command.
command.
[SENSe:]FREQuency:
on page 95
242