R&S FSW-K7 User Manual page 148

®
R&S FSW-K7
Remote commands:
CALCulate<n>:MARKer<m>:FUNCtion:PNOise[:STATe]
CALCulate<n>:MARKer<m>:FUNCtion:PNOise:RESult?
Phase Noise Measurement
Switching All Phase Noise Measurements
Phase Noise Measurement State
Activates or deactivates phase noise measurement at the marker position in the dia-
gram.
In the Analog Demodulation application, this function is only available for normal mark-
ers.
If activated, the normal markers display the phase noise measured at their current
position in the marker table.
For details see
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:PNOise[:STATe]
CALCulate<n>:MARKer<m>:FUNCtion:PNOise:RESult?
Switching All Phase Noise Measurements Off
Deactivates phase noise measurement for all markers.
Remote command:
CALCulate<n>:MARKer<m>:FUNCtion:PNOise[:STATe]
User Manual 1173.9240.02 ─ 23
Working with Markers in the R&S FSW Analog Demodulation application
State............................................................................... 148
Chapter 6.3.4.1, "Phase Noise Measurement
on page 353
on page 354
Off............................................................148
Marker",
on page 353
on page 354
on page 353
Analysis
on page 147.
148