R&S FSW-K7 User Manual page 81

®
R&S FSW-K7
The required connections between the R&S FSW and the oscilloscope are illustrated in
the dialog box.
Alignment consists of two steps. The first step requires a (temporary) connection from
the REF OUTPUT 640 MHZ connector on the R&S FSW to the CH1 input on the oscil-
loscope.
To perform the alignment, select the "Alignment" button.
If necessary, in particular after the firmware on the oscilloscope has been updated, a
self-alignment is performed on the oscilloscope before the actual B2000 alignment
starts. This may take a few minutes.
If the oscilloscope and the oscilloscope ADC are aligned successfully, a new dialog
box is displayed.
User Manual 1173.9240.02 ─ 23
Configuration
Input and Frontend Settings
81