R&S FSW-K7 User Manual page 227

®
R&S FSW-K7
<p>
Parameters:
<Unit>
Example:
Manual operation:
Triggering with Power Sensors
[SENSe:]PMETer<p>:TRIGger:DTIMe
[SENSe:]PMETer<p>:TRIGger:HOLDoff
[SENSe:]PMETer<p>:TRIGger:HYSTeresis
[SENSe:]PMETer<p>:TRIGger:LEVel
[SENSe:]PMETer<p>:TRIGger:SLOPe
[SENSe:]PMETer<p>:TRIGger[:STATe]
[SENSe:]PMETer<p>:TRIGger:DTIMe <Time>
This command defines the time period that the input signal has to stay below the IF
power trigger level before the measurement starts.
Suffix:
<p>
Parameters:
<Time>
Example:
[SENSe:]PMETer<p>:TRIGger:HOLDoff <Holdoff>
This command defines the trigger holdoff for external power triggers.
Suffix:
<p>
Parameters:
<Holdoff>
Example:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
1...4
Power sensor index
DB | PCT
*RST: DB
UNIT:PMET:POW:RAT DB
See "Unit/Scale" on page 85
..............................................................................227
...........................................................................227
...................................................................... 228
...............................................................................228
.............................................................................228
........................................................................... 229
.
1...4
Power sensor index
Range: 0 s to 1 s
Increment: 100 ns
*RST: 100 µs
PMET2:TRIG:DTIMe 0.001
.
1...4
Power sensor index
Time period that has to pass between the trigger event and the
start of the measurement, in case another trigger event occurs.
Range: 0 s to 1 s
Increment: 100 ns
*RST: 0 s
PMET2:TRIG:HOLD 0.1
Sets the holdoff time of the trigger to 100 ms
Configuring the Measurement
227