R&S FSW-K7 User Manual page 115

®
R&S FSW-K7
Remote command:
[SENSe:]ADEMod<n>:AF:SPAN:FULL
5.7.2.2 RF Evaluation
Access: "Overview" > "Demod Settings" > "Spectrum"
Or: "Meas Setup" > "Demod" > "Spectrum" tab
These settings are only available for RF evaluation, both in time and frequency
domain. Note that for RF data the center frequency and demodulation bandwidth corre-
spond to the settings defined in the "Input" and "Data Acquisition" configuration.
Center
Span............................................................................................................................115
Demodulation
RF Full
Center frequency
Defines the center frequency of the signal in Hertz.
The allowed range of values for the center frequency depends on the frequency span.
span > 0: span
f and span
max
Remote command:
[SENSe:]FREQuency:CENTer
Span
Defines the frequency span. The center frequency is kept constant. The following
range is allowed:
span = 0: 0 Hz
span >0:
span
User Manual 1173.9240.02 ─ 23
frequency.........................................................................................................115
Bandwidth............................................................................................ 116
Span............................................................................................................... 116
/2 ≤ f ≤ f
min center
depend on the instrument and are specified in the data sheet.
min
≤ f ≤ f
min span max
on page 271
– span /2
max min
on page 242
Configuration
Demodulation
115