Output Settings - R&S FSW-K7 User Manual

®
R&S FSW-K7
Reference Value
Defines the reference value to be used for relative demodulation results and recalcu-
lates the results. If necessary, the detector is activated.
Note: A reference value 0 would provide infinite results and is thus automatically cor-
rected to 0.1.
Remote command:
CONFigure:ADEMod:RESults:AM:DETector<det>:REFerence
CONFigure:ADEMod:RESults:FM:DETector<det>:REFerence
CONFigure:ADEMod:RESults:PM:DETector<det>:REFerence
Meas -> Reference
Sets the
measured value for all relative detectors.
Note: A reference value 0 would provide infinite results and is thus automatically cor-
rected to 0.1.
If necessary, the detectors are activated.
Remote command:
CONFigure:ADEMod:RESults:AM:DETector<det>:REFerence:MEAStoref
on page 282
CONFigure:ADEMod:RESults:FM:DETector<det>:REFerence:MEAStoref
on page 282
CONFigure:ADEMod:RESults:PM:DETector<det>:REFerence:MEAStoref
on page 282

5.8 Output Settings

● Output
● Analog Demodulation Output

5.8.1 Output Settings

Access: INPUT/OUTPUT > "Output"
The R&S FSW can provide output to special connectors for other devices.
For details on connectors, refer to the R&S FSW Getting Started manual, "Front / Rear
Panel View" chapters.
How to provide trigger signals as output is described in detail in the R&S FSW User
Manual.
Digital I/Q output is not available for Analog Demodulation measurements.
User Manual 1173.9240.02 ─ 23
Reference Value to be used for relative demodulation results to the currently
Settings..................................................................................................... 126
Settings.................................................................. 127
Configuration
Output Settings
on page 280
on page 280
on page 280
126