R&S FSW-K7 User Manual page 237

®
R&S FSW-K7
This command is only available if external generator control is active (see
EXTernal[:STATe]
Example:
Usage:
Manual operation:
[SENSe:]CORRection[:STATe] <State>
This command turns correction of measurement results (normalization) on and off.
The command is available after you have created a reference trace for the selected
measurement type with
This command is only available if external generator control is active (see
EXTernal[:STATe]
Parameters:
<State>
Example:
Manual operation:
[SENSe:]CORRection:TRANsducer:GENerate <Name>
This command uses the normalized measurement data to generate a transducer factor
with up to 1001 points. The trace data is converted to a transducer with unit dB and
stored in a file with the specified name and the suffix .trd under
c:\r_s\instr\trd. The frequency points are allocated in equidistant steps between
start and stop frequency.
The generated transducer factor can be further adapted using the commands descri-
bed in the "Remote Commands > Configuring the R&S FSW > Working with Transduc-
ers" section in the R&S FSW User Manual.
Parameters:
<Name>
Example:
Manual operation:
Programming Example for External Generator Control
The following example demonstrates how to work with an external generator in a
remote environment.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
on page 232).
CORR:REC
Event
See "Recall" on page 77
[SENSe:]CORRection:COLLect[:ACQuire]
on page 232).
ON | OFF | 1 | 0
*RST: 0
CORR ON
Activates normalization.
See "Source Calibration Normalize"
'<name>
CORR:TRAN:GEN 'SMW200A1'
Creates the transducer file
C:\r_s\instr\trd\SMW200A.trd.
See "Save As Trd Factor"
Configuring the Measurement
on page 77
on page 78
SOURce:
on page 235.
SOURce:
237