R&S FSW-K7 User Manual page 104

®
R&S FSW-K7
Remote command:
OUTPut:TRIGger<port>:DIRection
Output Type ← Trigger 2/3
Type of signal to be sent to the output
"Device Trig-
gered"
"Trigger
Armed"
"User Defined"
Remote command:
OUTPut:TRIGger<port>:OTYPe
Level ← Output Type ← Trigger 2/3
Defines whether a high (1) or low (0) constant signal is sent to the trigger output con-
nector.
The trigger pulse level is always opposite to the constant signal level defined here. For
example, for "Level = High", a constant high signal is output to the connector until you
select the
Remote command:
OUTPut:TRIGger<port>:LEVel
Pulse Length ← Output Type ← Trigger 2/3
Defines the duration of the pulse (pulse width) sent as a trigger to the output connec-
tor.
Remote command:
OUTPut:TRIGger<port>:PULSe:LENGth
Send Trigger ← Output Type ← Trigger 2/3
Sends a user-defined trigger to the output connector immediately.
Note that the trigger pulse level is always opposite to the constant signal level defined
by the output
output to the connector until you select the "Send Trigger" function. Then, a low pulse
is sent.
User Manual 1173.9240.02 ─ 23
(Default) Sends a trigger when the R&S FSW triggers.
Sends a (high level) trigger when the R&S FSW is in "Ready for trig-
ger" state.
This state is indicated by a status bit in the STATus:OPERation reg-
ister (bit 5), as well as by a low-level signal at the AUX port (pin 9).
For details, see the description of the STATus:OPERation register
in the R&S FSW User Manual and the description of the AUX port in
the R&S FSW Getting Started manual.
Sends a trigger when you select the "Send Trigger" button.
In this case, further parameters are available for the output signal.
Send Trigger function. Then, a low pulse is provided.
Level setting. For example, for "Level = High", a constant high signal is
on page 265
on page 266
on page 265
on page 266
Configuration
Trigger Configuration
104