R&S FSW-K7 User Manual page 189

®
R&S FSW-K7
11.4.2.1 RF Input
INPut:ATTenuation:PROTection:RESet
INPut:CONNector
INPut:COUPling
INPut:DPATh
INPut:FILTer:HPASs[:STATe]
INPut:FILTer:YIG[:STATe]
INPut:IMPedance
INPut:SELect
INPut:ATTenuation:PROTection:RESet
This command resets the attenuator and reconnects the RF input with the input mixer
after an overload condition occurred and the protection mechanism intervened. The
error status bit (bit 3 in the STAT:QUES:POW status register) and the INPUT OVLD
message in the status bar are cleared.
(For details on the status register see the R&S FSW User Manual).
The command works only if the overload condition has been eliminated first.
Usage:
INPut:CONNector <ConnType>
Determines whether the RF input data is taken from the RF input connector or the
optional Analog Baseband I connector. This command is only available if the Analog
Baseband interface (R&S FSW-B71) is installed and active for input. It is not available
for the R&S FSW67 or R&S FSW85.
For more information on the Analog Baseband Interface (R&S FSW-B71) see the
R&S FSW I/Q Analyzer and I/Q Input User Manual.
Parameters:
<ConnType>
Example:
Manual operation:
INPut:COUPling <CouplingType>
This command selects the coupling type of the RF input.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
...........................................................................................................189
.............................................................................................................189
.................................................................................................................190
..........................................................................................190
.............................................................................................. 190
...........................................................................................................191
.................................................................................................................191
Event
RF
RF input connector
AIQI
Analog Baseband I connector
*RST:
INP:CONN:AIQI
Selects input from the analog baseband I connector.
See "Input Connector"
Configuring the Measurement
............................................................................189
RF
on page 55
189