R&S FSW-K7 User Manual page 360

®
R&S FSW-K7
Before you can use the command, you have to select a limit line with
LIMit<k>:NAME
Suffix:
<n>
<k>
Parameters:
<State>
Manual operation:
CALCulate<n>:LIMit<k>:LOWer:THReshold <Threshold>
This command defines a threshold for relative limit lines.
The R&S FSW uses the threshold for the limit check, if the limit line violates the thresh-
old.
Suffix:
<n>
<k>
Parameters:
<Threshold>
Manual operation:
CALCulate<n>:LIMit<k>:NAME <Name>
This command selects a limit line that already exists or defines a name for a new limit
line.
Suffix:
<n>
<k>
Parameters:
<Name>
Manual operation:
CALCulate<n>:LIMit<k>:UNIT <Unit>
This command defines the unit of a limit line.
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
on page 360.
.
irrelevant
Limit line
ON | OFF | 1 | 0
*RST: 0
See "Visibility" on page 156
.
irrelevant
Limit line
Numeric value.
The unit depends on
on page 360.
*RST: -200 dBm
See "Threshold" on page 158
.
Window
Limit line
String containing the limit line name.
*RST: REM1 to REM8 for lines 1 to 8
See "Name" on page 158
CALCulate<n>:LIMit<k>:UNIT
Analyzing Results
CALCulate<n>:
360