R&S FSW-K7 User Manual page 233

®
R&S FSW-K7
SYSTem:COMMunicate:RDEVice:GENerator:LINK
SYSTem:COMMunicate:RDEVice:GENerator:TYPE
SYSTem:COMMunicate:TCPip:RDEVice:GENerator:ADDRess
SOURce:EXTernal:ROSCillator[:SOURce] <Source>
This command controls selection of the reference oscillator for the external generator.
If the external reference oscillator is selected, the reference signal must be connected
to the rear panel of the instrument.
Parameters:
<Source>
Example:
Manual operation:
SYSTem:COMMunicate:GPIB:RDEVice:GENerator:ADDRess <Number>
Changes the IEC/IEEE-bus address of the external generator.
Parameters:
<Number>
Example:
Manual operation:
SYSTem:COMMunicate:RDEVice:GENerator:INTerface <Type>
Defines the interface used for the connection to the external generator.
This command is only available if external generator control is active (see
EXTernal[:STATe]
Parameters:
<Type>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
INTernal
the internal reference is used
EXTernal
the external reference is used; if none is available, an error flag
is displayed in the status bar
*RST: INT
SOUR:EXT:ROSC EXT
Switches to external reference oscillator
See "Reference" on page 73
Range: 0 to 30
*RST: 28
SYST:COMM:GPIB:RDEV:GEN:ADDR 15
See "GPIB Address / TCP/IP Address"
on page 232).
GPIB | TCPip
*RST: GPIB
SYST:COMM:RDEV:GEN:INT TCP
See "Interface" on page 72
Configuring the Measurement
........................................................... 234
.......................................................... 234
.......................................... 234
on page 73
SOURce:
233