R&S FSW-K7 User Manual page 270

®
R&S FSW-K7
Example:
Manual operation:
[SENSe:]ADEMod<n>:ZOOM:STARt <Time>
The command selects the start time for the zoomed display of analog-demodulated
measurements in the specified window. The maximum possible value depends on the
measurement time, which is set and can be queried with the
MTIMe
If the zoom function is enabled, the defined number of sweep points are displayed from
the start time specified with this command.
Suffix:
<n>
Parameters:
<Time>
Example:
Manual operation:
[SENSe:]ADEMod<n>:ZOOM[:STATe] <State>
The command enables or disables the time domain zoom function for the analog-
demodulated measurement data in the specified window.
If the zoom function is enabled, the defined number of sweep points are displayed from
the start time specified with
If the zoom function is disabled, data reduction is used to adapt the measurement
points to the number of points available on the display.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
ADEM:ZOOM:LENG:MODE MAN
Zoom function uses the length defined manually.
See "Length"
command.
.
Window
Range:
*RST:
ADEM:ZOOM:STAT ON
Switches on the zoom function
ADEM:ZOOM:STAR 500us
Sets the starting point of the display to 500 µs.
See "Start"
[SENSe:]ADEMod<n>:ZOOM:STARt
.
Window
ON | OFF | 1 | 0
*RST:
ADEM:ZOOM ON
Switches on the zoom function
See "State"
Configuring the Measurement
on page 112
0 s to (measurement time – zoom length)
0 s
on page 112
0
on page 112
[SENSe:]ADEMod<n>:
on page 270.
270