R&S FSW-K7 User Manual page 192

®
R&S FSW-K7
Manual operation:
11.4.2.2 Using External Mixers
The commands required to work with external mixers in a remote environment are
described here. Note that these commands require the R&S FSW-B21 option to be
installed and an external mixer to be connected to the front panel of the R&S FSW.
In MSRA / MSRT mode, external mixers are not supported.
For details on working with external mixers see the R&S FSW User Manual.
● Basic
● Mixer
● Conversion Loss Table
● Programming Example: Working with an External
Basic Settings
The basic settings concern general usage of an external mixer.
[SENSe:]MIXer[:STATe]
[SENSe:]MIXer:BIAS:HIGH
[SENSe:]MIXer:BIAS[:LOW]
[SENSe:]MIXer:LOPower
[SENSe:]MIXer:SIGNal
[SENSe:]MIXer:THReshold
[SENSe:]MIXer[:STATe] <State>
Activates or deactivates the use of a connected external mixer as input for the mea-
surement. This command is only available if the optional External Mixer is installed and
an external mixer is connected.
Parameters:
<State>
Example:
Manual operation:
[SENSe:]MIXer:BIAS:HIGH <BiasSetting>
This command defines the bias current for the high (second) range.
This command is only available if the external mixer is active (see
STATe]
Parameters:
<BiasSetting>
User Manual 1173.9240.02 ─ 23
Remote Commands for Analog Demodulation Measurements
See "Radio Frequency State"
See "Digital I/Q Input State"
See "Analog Baseband Input State"
Settings....................................................................................................... 192
Settings....................................................................................................... 194
Settings........................................................................... 199
..................................................................................................192
............................................................................................. 192
............................................................................................ 193
................................................................................................193
................................................................................................... 193
............................................................................................. 194
ON | OFF | 1 | 0
*RST:
MIX ON
See "External Mixer State"
on page 192).
*RST:
Default unit: A
Configuring the Measurement
on page 53
on page 66
Mixer...................................... 203
0
on page 56
0.0 A
on page 68
[SENSe:]MIXer[:
192